Unit Ventilators
Built-Up Systems
Application SoftwareArchives
Built-Up Systems
Application SoftwareArchives
- AAF-HermanNelson (Revit 2010 Zip) - 41.2MB
Revit 2010 content for Built-Up System and Self Contained AAF®-HermanNelson® 2-pipe and 4-pipe unit ventilators, 750 – 1500 CFM vertical floor mounted and 750 – 2000 CFM horizontal ceiling mounted configurations. Electric heat, hot water, and steam heating coils are available, as well as chilled water and split-system DX cooling coils for the Built-Up System models. - Application Software for MicroTech® II Unit Ventilator Version 1.28 - 1,049K
MicroTech II Unit Controller Unit Main Control Board Application Software code version 1.28 for all software models. Please note that this must be downloaded with ServiceTools™ for MicroTech Applied Terminal Systems (ATS) Unit Controller Software Version 2.0 on units with firmware version 2.06 or newer. ! WARNING ! Downloading the wrong application can cause equipment damage and severe personal injury. Only trained technicians experienced with the particular equipment must use application codes. Installer assumes liability for use of correct codes. - ServiceTools™ for MicroTech II™ Applied Terminal System Unit Controller v1.1 (08/04) - 5,420K
ServiceTools for MicroTech II Applied Terminal System Unit Controller software v1.1 update. Note that this is not the full tool.
Important - Please Read Before Installing Update!
To install, click Download and save the zip file to your local hard drive. Open the zip file from your hard drive. Double-click on the ServiceTools .exe file to extract the update. ServiceTools files automatically default to C:\Program Files\McQuay ServiceTools\MicroTech II ATS. Both the full tool and this free update default to the same location. If you changed the default installation directory for the full tool, you must use the same directory for this update.